So, sometimes you may find that some packages are missing in your RouterOS such as NTP package, DUDE package, Wireless package, CAPsMAN package and so on. To use NTP client and server, ntp package must be installed and enabled.MikroTik RouterOS does not always include all the packages those are developed by MikroTik team. NOTE: the above logging rules work only with the built-in SNTP client, the separate NTP package doesn't have any logging facilities. Otherwise, packet is dumped as a list of field names and values, one per log line. If packet is shorter than the minimum 48 bytes, it is dumped as a hexadecimal string. OFFS - difference of two NTP timestamp values, in hexadecimal.ntp, debug, packet error sending to IP, restarting.ntp, debug, packet ignoring received PKT.ntp, debug, packet packet receive error, restarting.ntp, debug Wait for N seconds before restarting.ntp, debug Wait for N seconds before sending next message.
#MULTICAST PACKAGE MIKROTIK HOW TO#
See article " log" on how to set up logging and how to inspect logs. SNTP client can produce the following log messages.
ABCD is the short "kiss code" text from the Reference Identifier field. kod-ABCD - Received "KoD" (Kiss-o'-Death) response.bad-mode - Value of the Mode field is neither 'server' nor 'broadcast'.zero-transmit-timestamp - Transmit Timestamp field value is 0.server-not-synchronized - Leap Indicator field is set to "alarm condition" value, which means that clock on the server has not been synchronized yet.bad-packet-length - Packet length is not in the acceptable range.last-bad-packet-reason (Text read-only property) : Text that describes the reason of the last receive failure.last-bad-packet-before (Time interval read-only property) : Time since the last receive failure.Reason of the failure and time since this packet was received is available in the next two properties. last-bad-packet-from (IP address read-only property) : Source IP address of last received SNTP packed that was not successfully processed.last-adjustment (Time interval read-only property) : Amount of clock adjustment that was calculated from the last successfully received NTP server message.last-update-before (Time interval read-only property) : Time since the last successfully received server message.last-update-from (IP address read-only property) : Source IP address of the last received NTP server packed that was successfully processed.Values of the following properties are reset when the SNTP client is stopped or restarted, either because of a configuration change, or because of a network error. The initial value is 16 seconds, and it is increased by doubling to 15 minutes. poll-interval (Time interval read-only property) : Current interval between requests sent to the active server.This value is equal to primary-ntp or secondary-ntp. active-server (IP address read-only property) : Currently selected NTP server address.Domain name will be resolved each time NTP request is sent. Server-dns-names ( Comma separated domain name list default: ) Secondary-ntp ( IP address default: 0.0.0.0) If both values are non-zero, then SNTP client will alternate between the two server addresses, switching to the other when request to the current server times out or when the "KoD" packet is received, indicating that server is not willing to respond to requests from this client. IP address of NTP server that has to be used for time synchronization. Primary-ntp ( IP address default: 0.0.0.0) If there is dynamic or static NTP server ip address or FQDN used it will automatically switch to unciast mode" If no NTP servers are configured broadcast' mode will be used. Mode ( broadcast,unciast, filed is read-only) Enable SNTP client for time sychronisation
0 kommentar(er)
